5 Quick Steps to Install Shower Screen & Update Your Shabby Bathroom

Easy to install, convenient to use and stylish in look,  shower screen is the most trendy and low cost option to update typical bathrooms. It’s commendable regarding its function. However, the bath curtains are considered as its alternative but their unhygienic aspect makes them useless as compare to washable and safe shower screen.

Moreover, it’s not necessary to get quality product by bearing a load on your pocket, Fab Glass and Mirror is here to provide you the best range of glass screens with budget friendly offers. Not only this, we update it with easy and ready to go DIY glass products installation ideas. It doesn’t matter that you aren’t a hardware fixture expert or even going to deal with a shower screen for the very first time, it’s too simple and safe to install.

shower screen FAB glass and mirror

shower screen FAB glass and mirror

Follow 5 Easy Steps & Fix Shower Screen

Installation process needs some basic hardware which is mostly available at home; we’re not going to make it expensive.

Tools and Hardware:

  • Shower Screen
  • Drill
  • Screw driver
  • Tile Drill Bit
  • Wall Plugs
  • Measuring Tape
  • Screw Caps
  • Sealant
  • Spirit Level
  • Pencil

And of course, your little effort

VinesseLUX_VNXA-935CLSV

Let’s Get Started:

Step 1

Before installing the screen on wall, ensure the protection and remove all the possible hurdles. Then fix the seal at the bottom of shower and drill 3 holes into the wall channel at equal length along it.

Step 2

To fit the bath screen at the proper level of bath’s inside edge, move it into exact position. Again, ensure the position of wall channel in correct direction and nark the points to drill with the help of spirit level.

Step 3

Drill pilot holes for required depth. Then apply silicon sealant on the back of wall channel and insert the wall plugs, and secure with the help of screws by tapping with hammer but lightly.

Step 4

Now, it’s a time to have your shower screen inserted on the wall channel by tightening the screws from up and bottom. Ensure the seal at moderate level and don’t let it too tight that leaks may occur.

Step 5

Must cover the screws with caps, seal outer edges of screen by using sealant and don’t apply it inside the screen. Now, it’s about 50mm up the wall channel to meet and embellish it completely

2 Cantour Frameless Swing Door L

Well, that’s all about to enjoy a modern look of your bathroom in quick and easy way with Fab Glass and Mirror DIY ideas.

 

 

2 Comments
  1. April 7, 2017
    • April 19, 2017

Leave a Reply

Your email address will not be published. Required fields are marked *